TUNETRACKER SYSTEM IN ACTION - TuneTracker commands

# SS On/Off

It is possible to automatically turn the silence sensor feature on and off via your program log. This is done extremely easily, and is handy for situations where you are joining a live audio event that can have unpredictable amounts of silence such as a concert, church service, lecture, etc, or when you plan to use the "# Pause-For" event to pause the automation silently for a period of time, such as overnight. Note that in Command Center 3.2 and above, the silence sensor is "immune" to pause-for events, and thus you do not need to turn it off during a long, silent pause.

---

# SS On / # SS Off

•   Examples Using a Live Church Service:
  
  TuneTracker Basic™ Example
  
  # SS off
  # Live On
  # Pause-For 01:00:00
  # Live Off
  # SS On
  
  
  Two TuneTracker Command Center™ Examples
  
  # SS Off
  # Live-For 01:00:00
  # SS On
  
  
  # SS Off
  # Live-For 99:00:00
  # Interrupt@:59:00
  # SS On
  

•   Example Using a Pre-Recorded Program:
  
  # SS Off
  Play /boot/path/CityCouncilMeeting.mp3
  # SS On

In most situations, it's advisable to make certain the silence sensor is re-activated after the silency program is completed. For that reason, it's important that you do not create a situation where a Time-Correct or interrupt in your log can cause TuneTracker to skip-over a "SS On" event. If you are unsure whether that might occur, you are better off adding an extra "SS On" later in your log to make certain it is not turned off and left off.



Table of Contents